making in der schule
  • die idee
  • der raum
  • plotten
    • textiles beplotten
    • folien schneiden
    • verpackungen
  • 3d-drucken
    • projekte folgen
  • lasercutten
  • arduino
    • software
    • hardware
    • schaltung
    • übungen
    • projekte
  • links
  • kontakt
Sketch Beispiel Servo aus Arduino IDE 
Beispiel "Knob"
/*
 Controlling a servo position using a potentiometer (variable resistor)
 by Michal Rinott 

 modified on 8 Nov 2013
 by Scott Fitzgerald
 http://www.arduino.cc/en/Tutorial/Knob
*/

#include <Servo.h>

Servo myservo;  // create servo object to control a servo

int potpin = 0;  // analog pin used to connect the potentiometer
int val;    // variable to read the value from the analog pin

void setup() {
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
}

void loop() {
  val = analogRead(potpin);            // reads the value of the potentiometer (value between 0 and 1023)
  val = map(val, 0, 1023, 0, 180);     // scale it to use it with the servo (value between 0 and 180)
  myservo.write(val);                  // sets the servo position according to the scaled value
  delay(15);                           // waits for the servo to get there
}
Beispiel "Sweep"
/* Sweep
 by BARRAGAN 
 This example code is in the public domain.

 modified 8 Nov 2013
 by Scott Fitzgerald
 http://www.arduino.cc/en/Tutorial/Sweep
*/

#include <Servo.h>

Servo myservo;  // create servo object to control a servo
// twelve servo objects can be created on most boards

int pos = 0;    // variable to store the servo position

void setup() {
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object
}

void loop() {
  for (pos = 0; pos <= 180; pos += 1) { // goes from 0 degrees to 180 degrees
    // in steps of 1 degree
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
  for (pos = 180; pos >= 0; pos -= 1) { // goes from 180 degrees to 0 degrees
    myservo.write(pos);              // tell servo to go to position in variable 'pos'
    delay(15);                       // waits 15ms for the servo to reach the position
  }
}
oder zu hause      
  • die idee
  • der raum
  • plotten
    • textiles beplotten
    • folien schneiden
    • verpackungen
  • 3d-drucken
    • projekte folgen
  • lasercutten
  • arduino
    • software
    • hardware
    • schaltung
    • übungen
    • projekte
  • links
  • kontakt